Bathroom Chocolate Mary's Lacor

Bath chocolate

Elchocolatees a very delicate product: to melt so it must be done in your point just to avoid burning it or forming lumps. This Electric Bain-Marie allow to melt chocolate and keep it warm.

Easily prepare coverage for their cakes and you can use it as a fondue to bathe in your favorite snacks: try more or less intense chocolate, white chocolate, or add spices (cinnamon, ginger powder, pepper, vanilla) and vary the ingredients that will bathe in chocolate: cut cake into cubes, small pastries, cookies, Frostings, nuts fruit becomes a delicatessen even for people who normally do not eat it; In addition to classic strawberries, you will enjoy with sliced bananas or apples, berries, peaches, Pinauna healthy delight.

Characteristics of the bath chocolate from Lacor:

Power: 50 W
Maximum capacity: 1 litre
Temperature: 40-50 degrees
Weight: 875 g
Total size: 29 x 22 x 12 cm

Operation of the bath chocolate:

Place the saucepan of stainless steel inside the base. Add chocolate pearls, chopped or sliced and make sure that it does not exceed the recommended maximum weight so to melt not spilling out of the saucepan.

By placing the knob in position "MELTING" will begin the chocolate melting. After a few minutes make sure chocolate is melted, using a spatula or nonmetallic spoon to stir until its texture is uniform.

To keep warm chocolate previously melted place command in the 'WARM' position. To turn off the Bain Marie turn the knob to the OFF position.

Warning: Never mix water and chocolate, if it does not it will solidify again. Be sure to dry the spoons and spatulas being used with the melted chocolate.

Cleaning recommendations:

This product is not suitable for dishwashers. Before cleaning the bath chocolate make sure that the appliance is unplugged and at room temperature. Do not pour chocolate melted by the Desaga¼es, to solidify it can clog the pipes.

Remove the remains of chocolate which could remain stuck in the bucket and clean with plenty of hot water without abrasive products or metal sponges that may damage it. Be sure to dry all surfaces correctly.